Maydori Posted August 6, 2016 Report Share Posted August 6, 2016 'm using STM32L0 which was from http://www.kynix.com/Detail/1118455/STM32L062K8T6.html. My firmware operates at 2V. These are stepped down from 24V. If I have a short of the 24V for a short period of time this causes a brown out on my 2V the voltage begins to oscillate from my step down. I want to solve this with software. If seen that I don't get this problem without a load ( while(1), all peripherals turned off. ) I added a for-loop at the start of the program, that held for a few seconds, that didn't help. To me this means the program does not actually reset. Its somehow latches up unless the voltage drops bellow a threshold. Can I use under voltage detection or brown out detection of STM to prevent this? I need to force a reset as soon as the voltage drops bellow around 1.8V. I need to react, if I don't want an oscillation, within around 3ms. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.