Jump to content

Search the Community

Showing results for tags '74hc585'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Electronics Design
    • Electronic Projects
    • Electronics Theory
    • Power Electronics
    • Electronic Components
    • Spice Simulation
    • Datasheets
    • General Electronic Discussion
  • Digital Electronics & Microcontrollers
    • Microcontroller Projects / Programming
    • Arduino
  • PCB Design - Hardware
    • PCB Design Software / Questions
    • Mechanical Constructions
  • Others
    • Announcements
    • Feedback / Comments
    • Sell / Buy Electronics
    • Job Offer / Requests

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. I'm trying to pulse-width modulate an output from a 74HC585 shift register. To achieve this, I plugged a PWM output from a teensy 3.1 microcontroler into the output enable input of the 74HC595. The A output of the 74HC595 is then connected to the ground via a 640 Ohm resistor. Voltage between VCC and ground is 3.3V. Then I use the microcontroler to shift 0b00000001 to the 74HC595 and I start to PWM the output enable input at 50% duty cycle. Here is the datesheet of 74hc595 I expect to measure about 1.6V voltage between output A of the 74HC595 and ground. And indeed, if the PWM carrier frequency is slow (100 Hz), that's what I observe. Problem is, when I try to increase the PWM carrier frequency, the voltage between A and ground increase. For example, I measure 2.7V for a 10 KHz frequency. I measured the voltage between the teensy pwm output and ground, and it is as expected : 1.6 V. So, I know ICs can't be fed arbitrary high frequencies, but I was under the impression that 10 KHz doesn't qualify as high frequency. I seem to be unable to understand the problem, so here I am : can anyone explain me the reasons of this behavior ?
×
×
  • Create New...